|
- /*******************************************************************************
- This module contains WINC3400 ASIC specific internal APIs.
-
- File Name:
- nmasic.h
-
- Summary:
- This module contains WINC3400 ASIC specific internal APIs.
-
- Description:
- This module contains WINC3400 ASIC specific internal APIs.
- *******************************************************************************/
-
- //DOM-IGNORE-BEGIN
- /*******************************************************************************
- * Copyright (C) 2021 Microchip Technology Inc. and its subsidiaries.
- *
- * Subject to your compliance with these terms, you may use Microchip software
- * and any derivatives exclusively with Microchip products. It is your
- * responsibility to comply with third party license terms applicable to your
- * use of third party software (including open source software) that may
- * accompany Microchip software.
- *
- * THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES, WHETHER
- * EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE, INCLUDING ANY IMPLIED
- * WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY, AND FITNESS FOR A
- * PARTICULAR PURPOSE.
- *
- * IN NO EVENT WILL MICROCHIP BE LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE,
- * INCIDENTAL OR CONSEQUENTIAL LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND
- * WHATSOEVER RELATED TO THE SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS
- * BEEN ADVISED OF THE POSSIBILITY OR THE DAMAGES ARE FORESEEABLE. TO THE
- * FULLEST EXTENT ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN
- * ANY WAY RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY,
- * THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE.
- *******************************************************************************/
- // DOM-IGNORE-END
-
- #ifndef _NMASIC_H_
- #define _NMASIC_H_
-
- #include "nm_common.h"
-
- #define NMI_PERIPH_REG_BASE 0x1000
- #define NMI_CHIPID (NMI_PERIPH_REG_BASE)
- #define rNMI_GP_REG_0 (0x149c)
- #define rNMI_GP_REG_1 (0x14A0)
- #define rNMI_GLB_RESET (0x1400)
- #define rNMI_BOOT_RESET_MUX (0x1118)
- #define NMI_STATE_REG (0x108c)
- #define BOOTROM_REG (0xc000c)
- #define NMI_REV_REG (0x207ac) /*Also, Used to load ATE firmware from SPI Flash and to ensure that it is running too*/
- #define M2M_WAIT_FOR_HOST_REG (0x207bc)
- #define M2M_FINISH_INIT_STATE 0x02532636UL
- #define M2M_FINISH_BOOT_ROM 0x10add09eUL
- #define M2M_START_FIRMWARE 0xef522f61UL
- #define M2M_START_PS_FIRMWARE 0x94992610UL
-
- #define M2M_ATE_FW_START_VALUE (0x3C1CD57D) /*Also, Change this value in boot_firmware if it will be changed here*/
- #define M2M_ATE_FW_IS_UP_VALUE (0xD75DC1C3) /*Also, Change this value in ATE (Burst) firmware if it will be changed here*/
-
- #define REV_2B0 (0x2B0)
- #define REV_B0 (0x2B0)
- #define REV_3A0 (0x3A0)
- #define CHIP_ID_3000D (0x3000D0)
-
- #define GET_CHIPID() nmi_get_chipid()
- #define ISNMC1000(id) (((id & 0xfffff000) == 0x100000) ? 1 : 0)
- #define ISNMC1500(id) (((id & 0xfffff000) == 0x150000) ? 1 : 0)
- #define ISNMC3400(id) (((id & 0xfff0f000) == 0x300000) ? 1 : 0)
- #define REV(id) ( ((id) & 0x00000fff ) )
- #define EFUSED_MAC(value) (value & 0xffff0000)
-
- #define rHAVE_SDIO_IRQ_GPIO_BIT (NBIT0)
- #define rHAVE_USE_PMU_BIT (NBIT1)
- #define rHAVE_SLEEP_CLK_SRC_RTC_BIT (NBIT2)
- #define rHAVE_SLEEP_CLK_SRC_XO_BIT (NBIT3)
- #define rHAVE_EXT_PA_INV_TX_RX (NBIT4)
- #define rHAVE_LEGACY_RF_SETTINGS (NBIT5)
- #define rHAVE_LOGS_DISABLED_BIT (NBIT6)
- #define rHAVE_ETHERNET_MODE_BIT (NBIT7)
-
- typedef struct {
- uint32_t u32Mac_efuse_mib;
- uint32_t u32Firmware_Ota_rev;
- } tstrGpRegs;
-
- #ifdef __cplusplus
- extern "C" {
- #endif
- /**
- * @fn nm_clkless_wake
- * @brief Wakeup the chip using clockless registers
- * @return ZERO in case of success and M2M_ERR_BUS_FAIL in case of failure
- */
- int8_t nm_clkless_wake(void);
-
- int8_t chip_wake(void);
-
- int8_t chip_sleep(void);
-
- void chip_idle(void);
-
- void enable_rf_blocks(void);
-
- int8_t enable_interrupts(void);
-
- int8_t cpu_start(void);
-
- uint32_t nmi_get_chipid(void);
-
- uint32_t nmi_get_rfrevid(void);
-
- void restore_pmu_settings_after_global_reset(void);
-
- void nmi_update_pll(void);
-
- void nmi_set_sys_clk_src_to_xo(void);
-
- int8_t chip_reset(void);
-
- int8_t wait_for_bootrom(uint8_t);
-
- int8_t wait_for_firmware_start(uint8_t);
-
- int8_t chip_deinit(void);
-
- int8_t chip_reset_and_cpu_halt(void);
-
- int8_t set_gpio_dir(uint8_t gpio, uint8_t dir);
-
- int8_t set_gpio_val(uint8_t gpio, uint8_t val);
-
- int8_t get_gpio_val(uint8_t gpio, uint8_t* val);
-
- int8_t pullup_ctrl(uint32_t pinmask, uint8_t enable);
-
- int8_t nmi_get_otp_mac_address(uint8_t *pu8MacAddr, uint8_t * pu8IsValid);
-
- int8_t nmi_get_mac_address(uint8_t *pu8MacAddr);
-
- int8_t chip_apply_conf(uint32_t u32conf);
-
- #ifdef __cplusplus
- }
- #endif
-
- #endif /*_NMASIC_H_*/
|